Getting your Daikin BRC1C51/61 remote controller set up correctly is essential for managing your system efficiently. This wired controller is commonly used with Daikin's VRV and SkyAir systems.
Mode No. 12: Used to define the "Cool/Heat Selection" master if you have multiple units. 5. The Test Run
Step 7: Power Up and Test
Turn the breaker back on. The display should light up immediately.
Avoid Direct Sunlight: Don't mount the controller where the sun hits it.
3. Required Tools
- Phillips Head Screwdriver
- Flathead Screwdriver (for wiring terminals)
- Drill with appropriate bit (for wall mounting)
- Wire Strippers
- Multimeter (for safety checks)
- 2-core shielded cable (PVC cable typically acceptable, check local codes for gauge requirements—usually 0.5mm² to 2.0mm²).
To reset a Daikin fault, you must enter the diagnostic mode using the remote control to retrieve the fault code. Then, use the On/ Peninsula Air Conditioning Daikin iLINQ Quick Start Guide
7. Initial Setup After Power On
- Restore power to indoor unit.
- The remote will display “88” briefly, then a number (refrigerant address).
- Set the following via installer settings (hold Menu/Back + Button for 5+ seconds):
Appendices (recommendations)
- Appendix A — Typical wiring checklist: