Iprog Eeprom Adapter Pinout Portable //top\\ May 2026

iProg+ EEPROM adapter uses a standardized pinout designed for 8-pin chips (SOP8, SOIC8, DIP8) to facilitate reading, writing, and erasing data without complex wiring. The adapter connects to the main iProg+ unit through a DB44 connector

iPROG Portable Pinout Summary (quick reference)

If you're making your own cable or testing continuity:

Note: iPROG has multiple firmware modes (I²C, SPI, MicroWire). Pin functions change depending on protocol selected in software. iprog eeprom adapter pinout portable

Measuring roughly 12x7x5 cm, the adapter is built for high-speed diagnostic tasks on the go. Power Requirements:

Note: “iPROG” often refers to the Xgecu T48/T56 programmers or their clones. The common “EEPROM Adapter” for these is typically a SOIC8/SOP8 to DIP8 board (often labeled “iPROG Adapter” or “SOIC8 Test Clip Adapter”). iProg+ EEPROM adapter uses a standardized pinout designed

For 95% of EEPROM work (93Cxx, 24Cxx, 25Cxx series), you will use the 20-pin interface via a SOIC8 adapter.

The Standard iPROG Pin Assignment (J1 Connector)

The iPROG uses a multi-functional pin header. Pins serve dual purposes depending on the protocol (I2C, SPI, MicroWire). Below is the universal reference for the 10-pin or 16-pin connector typically found on iPROG clones. Measuring roughly 12x7x5 cm, the adapter is built

Which specific chip you are trying to read (e.g., 24C64, 35080)

This report details the pinout configurations and practical usage of portable iProg EEPROM adapters. Since the iProg programmer is a versatile device used for automotive mileage correction, airbag reset, and immobilizer programming, it supports a wide range of serial memory types (I2C, SPI, Microwire) via specific adapters.