01 Removing All — Jade Phi P47

Here is the Python feature implementation for the Jade project, removing the "phi p47 01" feature.

What "removing all" refers to? (e.g., removing a protective film, uninstalling software, disassembling a unit?) jade phi p47 01 removing all

If you are performing this operation within a software or project environment, consider the following standard practices: Documentation Verification : Always check the Official Documentation Here is the Python feature implementation for the

Hard Reset Procedure (Consult manual first)

1. Backup critical data – Use a USB drive or network share. Navigate to System > Backup > Export All. Save calibration files (*.cal), paste recipes (*.pst), and job files (*.job).
2. Enter service mode – Press and hold the reset button (location varies; typically behind the front panel) while booting.
3. Select “Factory Reset – Remove All” – The system will prompt: “Remove all user data, logs, and network settings? Yes/No”.
4. Confirm – Enter the service password (default is jade47service unless changed).
5. Wait for erase – The process takes 3-5 minutes. The P47-01 will reboot twice.
6. Reapply software baseline – After reset, you must reload the firmware from a recovery USB. Follow on-screen prompts.

Final system message:
REMOVE_ALL completed with residual vacuum. Total removal not possible. Jade Phi state minimal. Backup critical data – Use a USB drive or network share