Official Wiko Kite 4g L4020 Stock Rom Install [new] -

Guide: Installing Official Stock ROM on Wiko Kite 4G (L4020)

This guide outlines the steps to restore your Wiko Kite 4G to its official factory state. This process is useful for unbricking a soft-bricked device, removing viruses, bypassing lock screens, or simply reverting from a custom ROM back to stock.

Troubleshooting Common Errors

Error 4032 (BROM Error): Install the correct VCOM drivers. Try using a different USB port (preferably USB 2.0).
Error 5054 (BROM Error): This usually means the battery is too low. Charge the phone for 15 minutes and try again.
Stuck at Boot Logo: Perform a factory reset via Recovery Mode. To enter Recovery: Turn off phone -> Hold Volume Up + Power -> Select "Wipe Data/Factory Reset".

Wiko USB Drivers: Essential for your PC to communicate with the phone while it's powered off. official wiko kite 4g l4020 stock rom install

Troubleshooting:

Error: “STATUS_BROM_CMD_SEND_DA_FAIL” → Reinstall VCOM drivers or try a different USB port (use USB 2.0 if possible).
Error: “S_BROM_DOWNLOAD_DA_FAIL” → Disable driver signature enforcement on Windows, or try another version of SP Flash Tool.
Phone not detected → Ensure the phone is completely powered off (not just screen off). Remove battery (if possible) for 10 seconds.

: Ensure your battery is at least 50% charged to prevent a shutdown during the process, which could permanently "brick" the phone. Step-by-Step Installation Guide Prepare the Firmware Guide: Installing Official Stock ROM on Wiko Kite

In SP Flash Tool, click the “Scatter-loading” button.
Navigate to your extracted Stock ROM folder and select the file named MT6739_Android_scatter.txt (or similar – the name depends on the chipset; Wiko Kite 4G typically uses MediaTek MT6739).

Q3: Can I install a different country's firmware?

A: Not recommended. The Wiko Kite 4G L4020 may have different radio frequencies for Europe vs. Asia. Wrong firmware = no cellular signal. Error 4032 (BROM Error): Install the correct VCOM drivers